Craftsman 152.219110 Instruction Manual page 15

Figure 5-5 Figure 6°2
F
D
C
4, Open the chuck jaws compbteUy, hoUdthe top collar
(K) and turn the chuck barreU(L) counter-clockwise,
Make sure the jaws are compbteUy recessed inside
the chuck, See figure 5-5,
5, Seat the chuck onto the drHU press spindb as far as
it wHU go, Carefully drive the chuck onto the spindb
by pUacing a wooden bbck (M) under the chuck (N)
and tap the Mock up with a hammer (O),IMPOR-
TANT: DO NOT tap the chuck directly with a metaU
hammer,
LASER ASSEMBLY
2, Remove battery cover (C) from ]aser housing,
3, Connect a 9-voUt battery (D) (not incUuded) to
battery termina] (E),
4, PUace battery into battery compartment (F) and
repUace battery cover,
Figure 6-3
,, MAKE CERTAIN the drHU press is disconnected from
the power source,
LASER LIGHT o DO NOT STARE INTO BEAM,
APERTURE, or into a reflection from a mirror-like
surface,
Figure 6-1
Place clamp (A) through openings (B) in laser
housing,
5,
6,
15
Place laser around column (G) and against the
head casting (H) and fasten the clamp securely at
the column,
Make sure laser housing is positioned so that one
laser is to each side of the head casting,