Table of Contents
Advertisement
6. Attach
the four (4) lower stiffeners
to the
legs'. Two (2) truss head bolts,
washers,
and
nuts are required
to hold each end of a lower
stiffener
in place. Hand tighten
hex nuts.
Leg
7. Go back
with a 7/16 wrench
or socket
and
tighten
all hex nuts.
8. Carefully
lift the saw into its normal
posi-
tion. It will be necessary
to have someone
help
you in order to avoid damaging
the saw.
Adjusting Leveling Feet
[L
dl& WARNING:
Saw blade can roll for-
ward toward you if the leveling feet are not
correctly adjusted.
Workpiece or saw can
move unexpectedly
if cabinet rocks. Fin-
gers, hand, or arm can be cut off from
blade contact. Adjust leveling feet before
using your saw.
1. If the leveling
feet
raise
the front
of the saw
slightly
higher
than
the rear,
and if the leg set
does
not rock,
go to step 7, or
If the leveling feet do not raise the front of the
saw slightly higher than the rear, go to step 2, or
If the leg set rocks,
go to step 2.
2. Loosen
the bottom
hex nut on the desired
leveling
foot
using
a 9/16 inch
wrench.
3. Loosen
the top nut by hand.
4. Adust
the lower
nut with the 9/16 inch
wrench
until
the leveling
foot
is at the desired
height.
5. Tighten
the top nut by hand.
6. Repeat
steps2-5
for the other
three
leveling
feet
if necessary.
7. Tighten
all four bottom
nuts using
a 9/16
inch
wrench.
Attaching Trim Caps
1. Find
the left and right
trim caps.
2. There
are two plastic
stubs
on the back
of
each
trim cap.
3. These
stubs
will snap
into matching
holes
at
the front
corners
of the saw.
4. Snap
the left and right
trim caps into place.
Trim Cap
12
Hide quick links:
Advertisement
Table of Contents
