Squaring Blade To Table For Ripping - Craftsman 113.197110 Operator's Manual

Squaring Blade to Table for
Ripping
1. Unlock the swivel lock and turn the motor to
the out-rip position with the motor between
the blade and fence. (Figure 67)
/
I
\
Fig. 67 - Out-Rip Position
2. Lock swivel lock and rip lock.
3. Place the long edge of the framing square on
the table and the short edge against the blade
alongside the arbor shaft. Make sure the
square is against the surface of the blade and
not on the set of a tooth. (Figure 68)
4. Turn the blade with your hand Se_t
times and check to see if the squ_tr_lflt
with the blade.
5. If the square is flush with the blade after
each rotation (Figure 69) to step 11, or
If there is a gap between the square and the
blade after any rotation (Figure 69), go to
step 6.
I Right,
Table Fence
Wrong Wrong
-_n t I
Table ce Table Fence
Fig. 69
6. Loosen the hex nut on the rear carriage
bearing. Use a 9/16 inch wrench to hold the
bolt and a 1/2 inch wrench to loosen the nut.
(Figure 70)
Fig. 70
lift. 68
27