Building The Leg Set - Craftsman 113.197110 Operator's Manual

Leg
Support Bracket
Fig. 19
Hex Nuts
D
__keveling Foot
Building the LEG SET
The following parts are used in the leg set
assembly.
A Legs ........................... 4
B Lower Stiffeners ................. 4
C U-Channel ..................... 1
Fig. 20 - Leg Set
1. Lay a piece of cardboard on the floor to
keep from scratching the saw.
2. Position the basicsaw assembly on the floor
as shown below. The arm assembly should be
pointing up in a vertical position and the col-
umn support cover should be resting flat on
the floor. It may be necessary to have someone
help you lift the saw.
3. Use truss head bolts, lockwashers, and nuts
(see Fig. 22) to mount the two rear legs" to the
basic saw assembly. Make sure that the four
holes in each corner of the saw line up with
four holes in the top of each leg. Finger tighten
nuts at this time.
Switch Front
-- _ _tt_he_J'He_!
-- \ Floor
Column Support
Cover
4. Mount the two front legs to the basic saw
assembly using truss head bolts, lockwashers,
and nuts. However only put bolts through the
sides of the saw assembly not the front.
Fig. 22 - Bolt, External Lockwasher,
Hex Nut,
U-Channel
Saw Base
//_ Channel
Nut and Leg
Lockwasher
Truss Head Screw
Fig. 23
5. Position the front channelpiece inside the
legset. (Figure 23) Fasten the channelpiece,
leg, and saw together with two truss head bolts
on each side. Put a lockwasher and hex nut on
each bolt. The threaded section of the bolt
should point towards the arm assembly.
11