Adjusting Cutting Depth - Craftsman 137.407530 Operator's Manual

4. Adjust the fence 90 ° to the blade and
tighten the four fence locking bolts (1).
NOTE: If the saw has not been
used recently, recheck blade
squareness to the fence and
readjust if needed.
5. After fence has been aligned, using
a scrap piece of wood, make a cut
at 90 ° then check squareness on
the piece. Readjust if necessary.
Fig. S
3
ADJUSTING CUTTING DEPTH
(FIG. T, T-I)
The maximum depth travel of the
cutting head was set at the factory.
Setting the maximum width travel of
the cutting head, follow the below
steps (Fig. T):
1. Turn the stop knob (1) anti-clockwise
until the stop knob is not protruded
out of the stop block (4) bottom while
moving the cutting head upward.
2. Rotate the stop plate (2) clockwise
to touch the stop rod (3).
.
Recheck the blade depth by moving
the cutting head front to back
through the full motion of a typical
cut along the control arm.
Fig. T
1
3
\
\
2
Setting the maximum height travel
of the cutting head, follow the below
steps (Fig. "1"-1):
1. Turn the stop knob (1) anti-clockwise
until the stop knob is not protruded
out of the stop block (4) bottom while
moving the cutting head upward,
2. Rotate the stop plate (2) anti-
clockwise to touch the stop seat (5).
3. Make sure the stop block (4) touches
the stop plate (2) completely,
Fig. T-1
26