Mounting The Leg Stand On The Table Saw Base; Labels - Craftsman 315.228410 Owner's Manual

• Align the two large holes on the brace and the
legs. Insert the carriage bolts. Add fiat washers
and hex nuts and hand tighten. Repeat for the
other short upper brace. These are the front and
back sets.
• For the side sets, install a long upper brace on two
legs. Add hardware and finger tighten. Repeat for
the other long upper brace.
• Usa the same steps to install the lower braces.
Tighten all hex nuts with a 12 mm wrench.
• Place a hex nut and fiat washer on each leveling
foot. Install the leveling feet from the bottom of
each leg with the bolts pointing up. Cap with the
remaining fiat washers and hex nuts but do not
tighten.
• Move the leg set to desired location. Adjust the
leveling feet with a 12 mm wrench, then tighten the
top hex nut.
BRACE
LOWERBRACE
LEGSTANDASSEMBLED
Fig. 8
MOUNTING THE LEG STAND ON THE TABLE
SAW BASE
See Figure 9.
• Take the following from e small hardware bag:
4 hex bolts (5/16-18 x 1/2 in.)
4 hex nuts (5/16-18)
8 flat washers (5/16 in.)
Note: This hardware was in the bag with hardware for
assembling the leg stand and leveling feet.
• Place the saw table upside down on a smooth
surface, such as cardboard, on the floor.
_, WARNING: Do not lift the saw without help.
The saw base weighs approximately 95 Ibs. Hold
it close to your body. Keep your knees bent and
lift with your legs, not your back. Ignoring these
precautions can result in back injury.
• Place the leg stand on the table saw base. Align
the holes in the table with the holes in the end
braces. Make sure the Craftsman label faces the
front of the saw which has the height handwheel.
• Place a flat washer on a bolt and insert through
hole. Add a fiat washer and a hex nut. Hand
tighten.
• Repeat for three remaining holes. Tighten all
hardware with a 12 mm wrench. You may find it
helpful to use one wrench to hold the head of the
bolt and one to tighten the hex nut. Leave the saw
upside down to add the extensions.
LEG
STAND
RAT WASHER
HEXBOLT
SAWBASE
Fig. 9
19 [HFtSNAN'TABLE SAW 315,228410