Advertisement
STEP 9:
(SEE FIGURE 9)
*
Slide the front flaps of the hopper bag up onto the
front of the lower hopper tubes. Secure the bag frame
tube to the lower hopper tubes using two clevis pins
(28) and small hairpin cotters (19).
NOTE: Be sure front flaps of hopper bag are positioned
above clevis pins.
*
Snap the sides of the bag to the bottom of the bag at
the front corners.
STEP 11"
(SEE FIGURE 11)
*
Slide the assembled tubes down through the flaps in
the sides of the hopper bag (3) as shown.
28
FIGURE 9
STEP 10:
(SEE FIGURE 10)
*
Place two washers (42) between the middle holes in
a rear hopper tube (11 ). install two cotter pins (27)
into the holes, spreading the ends around the tube.
*
Assemble the rear hopper tube (11) to the two upper
hopper tubes (6) using two 1/4":< 1" curved head
bolts (26) and 1/4" nylock nuts (24). The bolt heads
should face up as shown in figure 10.
26
_
42
24
II
6
\
FIGURE 11
STEP 12:
(SEE FIGURE 12)
*
Slide the assembled tubes back up underneath the
wind screen as shown.
FIGURE 10
7
FIGURE 12
Advertisement
