Table of Contents
Advertisement
iiilI!i!
! ! !!!!
I l iiiliii ill ¸ I II I II I ii i i l iill i
iliiii ill i i ill IIIlil i l i ll i ! lilii_ii!i
I l ii ! I I I i:liii!
iiil i
Installation
instructions
Levellin 9 the @yet
Fig,37 Levelfing the dryer
f
Check the dryer is level, and make necessary adiustments
to the front levelling feet.
The rear levelling feet are self adiusting.
Final installation
check list
Checkthat:
No plastic or flexible metal foil is used in the exhaust ducting.
Exhaust is rigid ducting
or thick wall flexible
metal ducting.
All joints in the ducting
are made with duct tape. It must not be connected
with screws or other
fastening
devices whic h extend into the in side of the duct
,
Ducting is clean arid is connected
to the dryer,
i
,
Inserts are fitted to the two front feet
o Dryer _s _ eve_
across
the f ront
Additionally
for electdc @yet models only, check:
If installation
is 208V, special element kit has been fitted (seepage 21).
"
Dryer is plugged or directly wired into an approved fitting
and is properly
grounded,
i:,,
,
Dryer starts, heats, cools and shuts off.
o Customer
has b een shown how touse t he dryer
o Additionally
for gas @yet models only, check:
Dryer is plugged into an approved
fittirlg arid is properly
grounded,
i
All fittings
in the gas line are tested for leaks.
,
Exhaust temperature
increases, to confirm ignition
has occurred.
- If ignition does not occur initially, it may be due to air in the gas line or low voltage power supply.
The gas regulator valve m ay f aU toopen _ fthe p ower sopply falls below _0S Volts
- If the gas fails to flow or does riot ignite, the dryer will automatically
switch off.
,
Customer
has been shown how to use the dryer.
Note: AU dryers have adrum reversal
feature toreduce
clo_hes
_angle Throughout
the drying
cycle the motor will run for four minutes, then stop and run in the opposite
direction
for forty
seconds
before r eversing
again.
Advertisement
Table of Contents
