Table of Contents
Advertisement
ii@, !, i@@@@@@@@@@@@@@@@@@@@@@@@ilI_
i!llllii,
i! iil; _, i!_II_
iÀÀ I l il i ii:iiiiii
_ili
lii, i! ll:iiii,
i!_ iil' ii i ,i!_
l i . ...
Installation
instructions
Connecting gas to your dryer (gas models only)
Use compound
or thread tape appropriate
to the gas type that is to be used (Natural or LP Gas),
on the male threads of all non-flared
connections.
Never use an open flame to test for gas leaks.
This dryer will operate satisfactorily
up to altitudes
of 6500 ft (2000 m) above sea level at the
BTU rating indicated
on the model/serial
plate. Burner input adjustments
may be required if
operating
above this elevation.
The dryer must be disconnected
from the gas supply system dunng
any pressure testing.
Gas ignition
This dryer has an automatic
ignition
system to ignite the burner. There is no pilot flame burning
in this dryer.
Connecting to the gas supply
'I
The gas supply line should be V2inch.
2
An individual
manual shut--off valve must be installed on the gas supply line within 6 ft (1.8 m)
of the dryer, in accordance
with the National Fuel Gas Code ANSI Z223.1/NFPA
54 for the United
States or in accordance with the B149.1 Natural Gas and Propane Installation
Code for Canada.
An _2_
inch NPT p lugged
tapping must beinstaUed
toaUowthe
gas i nlet pressure
tobe checked.
Itmust beaccessible
forthe test g auge connection
and immediatel;,
upstream
ofthe gas
connection
to_he d ryer.
W' NPTplugg
pping
___________
Advertisement
Table of Contents
