Table of Contents
Advertisement
!!i
Ii liii ¸III
lil i ll,liiiiili, i ilill
l i !iiilli!i!iilti
Installation
instructions
3-wke
connections
Use approved
3--wire Power Supply Cord or a 3-wire Cable for Direct Wiring as described on
page 2S.
1
Remove
the terminal
block cover
plate,
2
Insert the power cord wi@ a UL listed strain relief through
the hole provided
in the cabinet
near
}:
the terminal
block. Do not tighten
strain
relief screw until wiring cormections
are complete.
Note: a strain relief must be used.
_@
,°-
@
.................................................................................
Fig.23
no we,' core/
3 Loosen orremove the center terminal block s crew. Connect theneutral wire/center/of
the
power supply cord to the center terminal
screw of the terminal
block. Tighten screw,
Cor,
r, e c_ _he other
w_res
to _he upper
and ,ower
term_r,a,
_,oc_
screws
mar_od
w_th
the , ether
_.
Tighten
screws.
4
5
tefit terminal
block cover
by inserting
the two tabs first on the rear panel of the dryer. Secure
cover with securing screw.
6 Tighten strain r elief screws.
....... s
_ -
6
iii
Fig 25 Refitting terminal block cover
Fig2d Tightening strain relid screws
Advertisement
Table of Contents
