WARNING: Many illustrations in this manual
show only portions of the Band Saw. This is
international so that points being made in the
illustrations can be highlighted. Never operate
the saw without all guards securely in place and
in good operating condition.
ASSEMBLY AND ADJUSTMENTS
Estimated Assembly Time: 50 - 60 minutes
WARNING: For your safety, never connect plug to
power source receptacle until all assembly and
adjustment steps are complete, and you have
read and understood the safety instructions.
Installing The Band Saw Table
(Fig. D, E, F)
1. Bag "E" - Loosen the table aligning bolt
the table aligning nut
2. Guide the table slot
27
3. Turn the scale pointer
the table by aligning the slot
with two pins
30
, then pull the table tilt adjustment
knob
21
out and the teeth of table tilt scale
with the teeth of the table tilt adjustment knob
shown on Fig. F.
4. Bag "D" - Insert the table lock handle
washer
and into the hole
31
handle
.
19
5. Turn the scale pointer
wrench. Adjust the table by aligning the zero scale mark
to the scale pointer
28
6. Replace the table aligning nut
and tighten with the table aligning bolt
Fig. D
Fig. E
8
and remove
26
from the table. (Fig. D)
over the saw blade
24
28
down clockwise and place
29
of table tilt scale
22
through the
19
, tighten the table lock
32
28
back and tighten it with a hex
.
back into the place
26
. (Fig. D)
8
26
8
24
27
Fig. F
22
29
Installing And Removing Blade (Fig. G, H)
WARNING: To avoid injury from accidental
starting, always turn the switch OFF and remove
the plug from the power source before moving,
replacing, or adjusting the blade.
. (Fig. E)
Removing (Fig. G, H)
22
1. Loosen the blade tension by turning the blade tension
knob
1
engage
2. Open the upper wheel cover
21
as
cover
12
lower cover lock knob
3. Remove the table aligning pad from the table.
4. Loosen the upper guide lock knob
of the band saw by turning it counterclockwise. (Fig. H)
5. Lower the upper blade guide
turning the blade guide height adjustment knob
6. Pull and open the blade guard
7. Remove the blade
and lower blade guide
8. Carefully pull the blade
and from the upper blade wheel
wheel
11
9. Hold the blade
guard slot
Fig. G
15
12
28
21
counterclockwise. (Fig. G)
15
by rotating the upper cover lock knob
10
.
6
to its lowest position by
5
24
from the upper blade guide
9
.
from the table slot
24
2
.
24
, slide it out from the left side blade
33
.
1
English
30
19
31
32
and lower wheel
3
and
25
on the rear side
4
.
as shown in Fig. H.
6
27
and lower blade
3
10
9