Nortel 1000 Con?guration guide Manual page 84

84 Configuring MCS 5100
3
Communication Server 1000 to MCS 5100 Converged Desktop Type 2 Configuration Guide
Copyright © 2005-2008, Nortel Networks
.
This is the HLOC + DN of the converged telephone. This number
is used for Click-to-Call in Converged Mode, and must be a UDP
number.
b. Enter 6139625573 in the Public Charge ID text box.
This is the NPA + NXX + DN of the converged telephone. It is the
caller identification information sent on a public call. This value is
required, and may be need even in Unconverged Mode.
c. Select cdCOS from the Class of Service drop-down list.
This is the same Class of Service configured in
"Configuring a route list" (page
Note: You do not have to configure an alias, but if you do,
ensure that it does not conflict with the alias properties
configured in
d. Click Save.
Set up the converged properties, as follows:
a. Click Converged Desktop properties.
The Converged Desktop Data web page opens, as shown in
Figure 35 "Provisioning Client: Converged Desktop Data" (page
84).
Figure 35
Provisioning Client: Converged Desktop Data
b. Enter 000023345573 in the Converged Desktop Alias text box.
This is the PNI + HLOC + DN of the converged telephone.
c. Enter one of the following values in the Converged Desktop
Preferred Audio Device text box:
• If you are configuring UDP, enter the Access Code (AC1 or
AC2) + HLOC + DN of the converged telephone.
Nortel Communication Server 1000
NN43001-321 01.05 Standard
Release 5.0 15 February 2008
75).
Step 3.
Procedure 5