Installing Belt Guard Knob - Craftsman 113.213130 Owner's Manual

5. Locate V-belt in the loose parts bag.
6. Use speed chart inside belt guard to choose speed
for drilling operation. Install belt _n correct pos_t_on
for desired speed
NOTE: Refer to chart inside belt guard for Recc)m-
mended Drilling Speeds.
7. Apply tension to belt by turning Belt Tension Han:l e
counter clockwise until belt deflects app_oximateiy
!/2 inch by thumb pressure at _ts center
8. Tighten Belt Tension Lock Handles
CAUTION: Over tensioning belt may cause motor not
to start or damage bearings.
9. If belt slips while drilling, readjust belt tenson
V-BELT
\
SPINDLE
PULLEY
MOTOR
PULLEY
_. 1 _ BELT
.................. , ......... TENSION
;I LOCK
HANDLE
BELT GUARD
5ram DIA x 12ram LONG
SCREW
BELT GUARD KNOB
INSTALUNG BELT GUARD KNOB
t, To attach belt guard knob. locate knob and 5ram
Dia. x 12mm long pan hd. screw in loose parts
bag. Install screw in hole Iocaled in guard and at-
tach knob turning until tight.
WARNING: TO AVOID POSSIBLE INJURY KEEP
GUARD IN PLACE AND IN PROPER WORKING
ORDER WHILE OPERATING,
13