Craftsman 113.213130 Owner's Manual page 9

mecation and functien ef centrols
1. BELTTENSION HANDLE..• Turn handle counter
clockwise to apply tension to belt. turn handle
clockwise to release belt tension,
2. BELT TENSION LOCK HANDLE... Tightening
handles locks motor bracket support and BELT
TENSION HANDLE to maintain correct bett dis-
tance and tension
3. HEAD LOCK SET SCREWS... Lock the head
to the column, ALWAYS have them locked in place
while operating the drill press
4. SUPPORT LOCK •.. Tightening locks table sup-
port to column, Always have it locked in place while
operating the Drill Press
5. TABLE CRANK . , . Turn clockwise to elevate
table Support lock must be released before operat-
ing crank.
6. TABLE BEVEL LOCK.., Locks the table in any
position from 0-45
7. TABLE LOCK . . , Allows table to be rotated in
various positions and locked
8. FEED HANDLE . . . For moving the chuck up or
down One or two of the handles may be removed
if necessary whenever the workpiece is of such
unusual shape that it interferes with the handles
4
10
11
9. CHUCK.., Holds drill bit or other recommended
accessory to perform desired operations.
10. BEVEL SCALE, . . Shows degree table is tilted
for bevel operations. Scale is mounted on side of
arm
11. SPRING CAP, . . Provides means to adjust quill
spring tension,
12. DEPTH SCALE... Allows operator to adjust drill
press to drill to a desired depth.
13. DRILL "ON-OFF" SWBTCH . . . Turns drill press
on and off .... also used to lock drill press in off
position.
14, CHUCK KEY... Used to tighten drill in the chuck
and also to loosen the chuck for drill removal.
15. DEPTH SCALE LOCK.,. Locks the depth scale
at selected depth,
15
12
1
3
8