Hole Location; Feeding; Adjustments - Craftsman 113.213130 Owner's Manual

TILTING TABLE
i
: : To use the table in a bevel ttilted) position, loosen the
set screw under table bevel lock with Hex "L" wrenchl
Loosen bevel Iodk With adjustabie Wrench:
iTilt tab e to desired angle by reading bevel scale. Rei
tighten bevel lock and set screw.
BEVEL
(3
SET SCREW
:VEL LOCK
WARNING: TO AVOID INJURY FROM SPINNING
WORK OR TOOL BREAKAGE, ALWAYS CLAMP
WORKPIECE AND BACKUP MATERIAL SECURELY
TO TABLE BEFORE OPERATING DRILL PRESS
WITH THE TABLE TILTED.
To return table to original position: loosen set screw
and bevel lock, tilt table back to 0° on bevel scale, and
retighten set screw--then tighten bevel lock.
HOLE LOCATION
Make a DENT in the workpiece where you want the
hole.., using a CENTER PUNCH or a SHARP NAIL.
Before turning the switch ON, bring the drill down to
the workpiece lining it up with the hole location,
FEEDING
Pull down on the feed handles with only enough effort
to allow the drill to cut.
Feeding TOO SLOWLY might cause the drillto burn
. . , Feeding TOO RAPIDLY might stop the motor...
cause the belt or drill to SLIP ... tear the workpiece
LOOSE or BREAK the drill bit.
When drilling metal, it may be necessary to lubricate
the tip of the drill with motor oi! to prevent burning the
drill tip.
adjustments
WARNING: FOR YOUR OWN SAFETY TURN
SWITCH "OFF" AND REMOVE PLUG FROM POWER
SOURCE OUTLET BEFORE MAKING ANY ADJUST-
MENTS. TO AVOID INJURY FROM THROWN PARTS
DUE TO SPRING RELEASE, FOLLOW INSTRUC-
TIONS CAREFULLY, AND WEAR EYE GOGGLES.
QUILL RETURN SPRING
NOTCH
JAM NUT
(OUTER)
BOSS
SPRING CAI
1. With the chuck at its highest possible position, turn
the depth scale clockwise until it stops and tighten
the depth scale lock. This will prevent the quill drop-
p_ngwhile tensioning the spring.
2. Lower table for additional clearance
3. Work from left side of Drill Press."
4. Place screwdriver in lower front notch of spring
cap, and hold it in place while loosening and remov-
ing jam [outer] nut only.
5. With screwdriver remaining in notch, loosen large
standard [inner] nut (approximately 1/8") until notch
disengages from boss on head. DO NOT REMOVE
THIS NUT.
6. Carefully turn screwdrMpr counter clockwise and
engage next notch in boss. DO NOT REMOVE
SCREWDRIVER
NUT
(INNER)
8,
Move stop nuts and depth pointer to upper most
position and check tension whi_e turning feed han-
dles.
9. If there is not enough tension on spring, repeat
steps 4-8 moving only ONE notch each time and
checking tension after EACH repetition.
10. Proper tension is achieved when quilt returns gently
to full up position when released from 3/4" depth.
11. When there is enough tension after checking, re-
place jam nut and tighten to standard nut, BUT do
not overtighten against standard nut.
7. Tighten standard nut with wrench only enough to 12. Check quill while feeding to have smooth and un-
engage boss. Do not overtighten as th s w restr Ct restricted movement If movement s too t ght
quill movement, loosen jam nut and SLIGHTLY loosen standard
nut until unrestricted. Retighten jam nut.
24