Installing Belt Guard Knob; Tensioning Belt - Craftsman 113.213100 Owner's Manual

BELT GUARD KNOB
5mm DIA, × 12ram LONG
CROSS RECESS SCREW
INSTALLING BELT GUARD KNOB
1. To attach belt guard knob, use knob and 5mm Dia.
x 12mm long pan hd. screw in loose parts bag. tnstalf
screw in hole located in guard and attach knob, turn-
ing until tight.
WARNING: To avoid possibHe injury keep guard
in place and in proper working order while
operating.
TENS_ONING BELT
NOTE: The Drill Press is shipped with the belt installed,
but it should be properly tensioned before use.
1. Lift guard from right side and leave opened on
hinge.
2. Release Belt Tension Lock Handle located on right
side of Drill Press head. Puit right side of motor
toward front of dHII press to relieve spring tension
on belt. Tighten the belt tension lock handle.
PAN HD. SCREW
3. Choose speed for drilling operation, and move belt
to correct position for desired speed.
NOTE: Refer to chart inside belt guard for Recom-
mended Drilling Speeds.
4. Loosen belt tension lock handle and move right
side of motor rearward to apply tension to the belt.
5. Tighten Belt Tension Lock Handle.
NOTE: Belt SHOULD deflect approximately 1/2" by
thumb pressure at mid-point of belt between pulleys.
6. Close belt guard.
7. If belt slips while drilling, readjust belt tension.
i LOCK HANDLE
13