Adjusting Rip Scale Indicator; Installing Blade Guard; H Hex Nut - Craftsman 113.298032 Owner's Manual

3,
The rip fence must be PARALLEL with the sawblade
(see page 31) ana miter Gauge grooves.. Move fence
until it is along side of groove. Do NOT LOCK IT. !t
should be parallel to groove. If it is not;
A. Loosen the two "'Hex. Head Screws."
B. Hold fence head tightly aga=nst bar . . move end
of fence so that it is parallel with groove.
C. Alternately tighten the screws.
SCREWS
FENCE HEAD
ADJUSTING RIP SCALE INDICATOR
1. Turn ELEVATION HANDWHEEL
2.
3.
clockwise until
blade is up as high as it will go.
IMPORTANT: BLADE must be SQUARE {90 °) to
TABLE, in order to ALIGN rip fence.
Using a rule, position fence on right side of sawblade 2
in. from tt_e sides of the teeth.., tighten lock handle.
Loosen screw holding the indicator.., adjust so that it
points to "2" on the rip scale.., tighten screw.
NOTE: If you cannot adjust indicator so that it points
to "2", loosen the screws holding the front guide bar
and move the guide bar.
\
LOCK HANDLE
INSTALLING BLADE GUARD
1. From among the loose parts, find
2 Hex Head Screws, 1/4 - 20x 5/8 in. long ......
2 Hex Head Screws, 5/16- 18x 5/8in. long
2 Hex Head ScrewS, 5/16- 18 x 1 in. long
2 Hex Nuts, I/4 - 20
(approx. dia. of hole 1/4 in.)
2 Lockwashers, 1/4 in. External Type
(approx. dia. of hole 1/4 in.)
2 Lockwashers, 5/16 in. External Type
(approx. dia. of hole 5/16 in,)
1 Thumbscrew .........
Guard Support
Spreader Support
Spreader Rod
2, Lower the blade ..........
3. Screw the two MOTOR BASE CLAMP SCREWS part
way into cradle.
4. Attach GUARD SUPPORT... DO NOT TIGHTEN
screws.
GUARD SUPPORT
5/]6_18 X
HEX
SCREW
5/16-18 X 1' IN.
HEX HD. SCREW
14