Table of Contents
Advertisement
ADJUSTING
RIP SCALE
INDICATOR
IMPORTANT:
BLADE must be SQUARE
(90° ) to
TABLE, in order to ALIGN rip fence.
1. Using a rule, position fence on right side of
sawblade
2
in.
from
the
sides
of
the
teeth..,
tighten lock handle.
2. Loosen screw holding the indicator..,
adjust
so
that
it
points
to
"2"
on
the
rip
scale..,
tighten screw.
NOTE: If you cannot adjust indicator so that it
points to "2", loosen the screws holding the
front guide bar and move the guide bar.
\
\
LOCK
HANDLE
iNSTALLiNG
BLADE
GUARD
1. From among the loose parts, find
2 Hex Head Screws, 1/4-20 x 5/8 in. tong
1 Hex Head Screw, 5/16-18 x 5/8 in. long
2 Hex Head Screws, 5/16-18 x 1 in. long
2 Hex Nuts, 1/4-20
(approx. dia. of hole 1/4 in.)
2 Lockwashers,
1/4 in. External Type
(approx. dia. of hole 1/4 in.)
2 Lockwashers,
5/16 in. External Type
(approx. dia. of hole 5/16 in.)
1 Thumbscrew
Guard Support
Spreader
Support
Spreader Rod
2. Attach
GUARD
SUPPORT
DO
NOT
TIGHTEN
screws.
3. Assemble
5/16-18
x 5/8 hex head screw into
GUARD SUPPORT.
GUARD
SUPPORT
5/16-18
X
5/8 IN.
HEX HD.
SCREW
5/16-18
1 IN.
HEX HD. SCREWS
5/16 IN.
4. Insert
SPREADER
ROD
into
SPREADER
SUPPORT
until
pin
fits
into
notch.
Insert
Thumbscrew
and tighten it.
THUMB
SCREW
SPREADER
ROD
FLAT
SURFACE
_
(INTO SUPPORT)
U
SPREADER
SUPPORT
18
Advertisement
Table of Contents
