Assembling Steel Legs; Mounting Saw; K Truss Head Screw; Leveling Foot - Craftsman 113.298032 Owner's Manual

ASSEMBLING STEEL LEGS
NOTE: Steel Legs are furnished wLth Model 113.298032
and 113.298240. From among the loose parts, find the
following Hardware:
24 Truss Head Screws, 1/4 - 20 x 5/8 in. long (top of
screw is rounded)
24 Lockwashers, 1/4 in. External Type (approx. dia. of
hale 1/4 in.)
24 Hex Nuts, 1/4 - 20 (approx. dia. of hole I/4 in.)
8 Hex Nuts, 1/2 - 13 (approx. dia. of hole 1/2 in.)
4 Leveling feet.
Assemble the legs as shown ...
1. Insert the Truss Head Screws through the holes in the
legs, then through the holes in the stiffeners. MAKE
SURE THE SCREWS GO THROUGH THE HOLES IN
THE SIDE STIFFENERS MARKED "X "°.
2. Install the Iockwashers ... screw on the nuts but do
not tighten until completely assembled.
3. Install leveling feet.
END
STIFFENER"
SIDE STIFFENER
IN. HEX NUTS
MOUNTING SAW
1. From
2.
3.
among the loose parts, find the following
hardware:
4 Hex Head Screws, 5/16 - 18 x 1-1/4 in. long.
4 Hex Nuts, 5/16 - 18 (approx. dia. of hole 5/16 in.)
4 Lockwashers, 5/16 in. External Type (approx. dia. of
hole, 5/16 in.)
8 Flat Washers, (dia. of hole 11/32 in.)
Place saw on legs so that holes in bottom of saw line up
with holes in top of legs.
Instatl screws, washers, Iockwashers and nuts as shown.
SAW BASE [
HEX H A0 SCREW
FLAT 1
END i _E_ "
STIFFENER-"-_1 1
FLAT WASHER----__
LOCKWASHER "I'"_'
HEX N UT '_"_'_U_
If you mount the saw on any other bench, make sure that
there is an opening in the top of the benc h the same size as
the opening in the bottom of the saw so that the sawdust
can drop through. Recommended working height is 33 to
37 inches from the top of the saw table to the floor.
7/]6 DIA HOLES