Craftsman 113.298032 Owner's Manual page 28

When "WIDTH OF RIP" is 2 in. to 6 in. wide USE THE
PUSH STICK to feed the work.
When WIDTH OF RIP is NARROWER than 2 in,, the push
stick CANNOT be used 10ecause the guard will interfere...
USE the AUXILIARY FENCE/WORK SUPPORT ane
PUSH BLOCK.
Attach Auxiliary Fence/Work Support to rip fence with
two "'C'" clam _s.
\
Feed the workpiece by hand along the AUXILIARY
FENCE until the end s approx. 1 n. oast the front edge of
the table. Continue [o feed using the PUSH BLOCK.
Hold the worKpiece in oosition and install the PUSH
BLOCK by sliding it on top of the AUXILIARY
FENCE/WORK SUPPORT (This May Raise Guard)
BAFFLE
/
Narrow strips thicker than the Auxiliary Fence?Work
Support may enter the gJard and strike the baffle.
CAREFULLY raise guard only enough to clear the
workoiece. Use PUSH BLOCK to complete cut.
28