Printing A Menu Map; Printing A Demo Page; Checking The Finisher Operation - Oki C9300 User Manual

some value greater than 1, then press Select (3) to confirm
your selection.
4. Press Item (1) until Output Bin appears. Press Value (2) to
cycle through the available options and press Select to enable
the desired choice. The standard bin is the bin on top of the
printer, the first option bin is the Finisher's face-up stacker,
and the second option bin is the Finisher's face-down (staple)
stacker.
5. Press Item (1) until Hole Punch appears. Press Value (2) to
see either On or Off and press Select to enable the desired
choice.
6. Press Item (1) until Staple appears. Press Value (2) to see
either On or Off and press Select to enable the desired choice.
7. Press Item (1) until Job Offset appears. Press Value (2) to see
either On or Off and press Select to enable the desired choice.
8. Press Item (1) until Paper Feed appears. The display will
prompt you for your preferred feed tray. Press Value (2)
several times to cycle through the available trays. When the
tray you wish to feed from is displayed, press Select (3) to
confirm your selection.
9. Press Online to exit the menu system and return the printer to
standby operation.

Printing a Menu Map

This function prints a map of all the menu settings and shows all
the new settings now available with your Finisher installed.
1. Press Menu (0) to access the Information Menu.
2. Press Item (1) and then press Select (3) to confirm that you
wish to print the menu map. After a few seconds the menu
map appears over two pages. These may be punched and/or
stapled, depending on the selections you made in the previous
section.

Printing a Demo Page

The built-in demo page can also be used to check that the various
functions of your Finisher perform correctly.
1. Press Menu (0) to access the Information Menu. If you have a
hard disk installed you will need to press Menu (0) twice to
access the Information Menu.
2. Press Item (1) several times until prompted to print a demo
page, press Select (3) to print the page.

Checking the Finisher Operation

1. Changing the output bin.
Use the procedure described earlier to choose each of the Fin-
isher settings, print a menu map or multiple copies of demo
pages using each of the available output bins to ensure that
paper is stacked in the correct bin.
Note that the size of paper which can be accommodated in
each bin is restricted, so be sure to choose an appropriate
paper size for each bin. (All bins can accommodate A4 or Let-
ter sizes, so these might be the most convenient sizes for test-
ing.)
13