Oki C9300 User Manual page 44

a. Rotate the Finisher Guide (1)
upwards and hold it in the raised
position while you carefully
remove the Chip Box (2).
b. Lower the Finisher Guide (1)
back into position.
Note: Be careful not to spill the punch
chips by tilting the Chip Box
too much.
c. Dispose of the punch chips.
3. Refit the punch Chip Box
a. Rotate the Finisher Guide (1) upwards and hold it in the
raised position while you refit the Chip Box (2).
b. Lower the Finisher Guide (1) back into position.
4. Attach the Finisher to the printer.
a. Push the Finisher towards the
printer until it clicks into
position.
1
b. Return the Decurler Lever (1)
to the horizontal position.
Note 1:If the Decurler Lever is not
returned to the horizontal
2
position, it may cause the
paper to jam.
Note 2:If the punch Chip Box has
not been properly fitted, the
following error message
will occur at the printer
control panel:
CHECK PUNCH CHIP
BOX
472: PUNCH CHIP BOX
MISSING
41
1