down the cover while pressing on the front of the tab (2) with
a flat blade screwdriver to remove the printer cover.
5. Remove the two screws. Fit the bracket (1) using these two
screws. This will stabilize the lower Auxiliary tray with the
printer.
6. Refit the printer access cover previously removed by clicking
it into place and then refitting the retaining screw.
1
2
WARNING:
The Finisher weighs 55 lbs. (25kg.) Do not attempt to lift it
without assistance.
7. Mount the Finisher on the Cabinet as shown in the Cabinet
Installation Guide or on a flat surface (not illustrated). Extend
the telescopic slide (1) from the Finisher to its limit.
9
1