HP Surestore 125ex - Optical Jukebox Manual page 30

1
1
S
ETTING UP THE
6. Set up the jukebox at its new location, following the procedures in the beginning of this chapter.
S
HIPPING THE
1. Unmount any optical disk surfaces in the jukebox if necessary.
See your computer operating system, or software application documentation for instruction on how to unmount
NEXT
optical disks.
2. Eject all disks from the jukebox.
PREVIOUS
If you will be replacing the disks into this jukebox after shipment, it is recommended that you label the disks at this
time to at least show their slot location inside the jukebox. This will aid the setup at the new location.
Refer to your jukebox application software documentation for instructions on how to eject disks from the jukebox.
JUMP
If you will be manually ejecting disks, refer to
disks so that the labeling will not cause problems in the jukebox, refer to
page
CONTENTS
Caution:
Caution:
INDEX
3. Switch the jukebox standby/on switch to STANDBY (see "2" on
J
UKEBOX
J
UKEBOX
2-3.
Failure to eject a disk from the optical drive prior to moving the jukebox could result in damage to the optical drive mechanism.
Failure to remove all disks from the storage slots in the jukebox could result in damage to the jukebox
Do not turn off power to the jukebox until you are sure the SCSI bus is inactive. Removing power from a SCSI peripheral when
the bus is active can result in data loss and/or indeterminate bus states. Check your host system manuals for information about
checking the SCSI bus status.
If your computer is connected to a LAN, ensure that other users on the LAN are not accessing the jukebox.
"Ejecting a Disk Cartridge From the Jukebox" on page
"Labeling an Optical Disk Cartridge" on
Figure 1-1).
3-11. To label
.
19