HP Surestore 125ex - Optical Jukebox Manual page 26

1
1
S
ETTING UP THE
Drive 1 = 4
Drive 2 = 5 (if installed)
NOTE:
NEXT
PREVIOUS
JUMP 1. Ensure that the mailslot shipping bracket and the shipping screw are removed.
NOTE:
2. Ensure that your host computer is OFF and the jukebox standby/on switch is in the STANDBY position.
CONTENTS
The jukebox standby switch is in STANDBY when the STANDBY side of the switch is depressed. The switch is
shown by "2" on
INDEX 3. Connect SCSI cables between the host, the jukebox, and the other peripheral (perhaps another jukebox) as shown in
Figure
4. Depending on your bus type, put a single-ended, low-voltage, or SE/LVD terminator on the SCSI connector of the
last peripheral on the bus.
Caution:
5. Go to the next steps,
J
UKEBOX
If you determine that there are conflicts among SCSI IDs that are currently in use by your system and peripherals you
will be placing on the bus, plan to do the following steps, as they apply to your situation.
• If you choose to change IDs used by internal devices, change the IDs at this time (before you turn the host system
OFF).
• If you choose to change the IDs of external peripherals (other than this jukebox) you may want to change those IDs
at this time.
• If you choose to change the IDs in this jukebox (or an additional jukebox of this model), you can do this during the
next set of steps "Connecting Power, Adjusting IDs, and Turning the Jukebox
two libraries of this type, they will have the same default IDs (3, 4, and 5).
If you will be changing SCSI IDs in the host, finish changing them before doing the next step. See the previous NOTE.
Figure 1-1.
1-5.
Do not use a high-voltage differential terminator.
"Connecting Power, Adjusting IDs, and Turning the Jukebox
On". Remember, if you are installing
On".
15