HP Surestore 125ex - Optical Jukebox Manual page 27

1
1
S
ETTING UP THE
C
ONNECTING
THE
NOTE:
NEXT
1. Ensure that your host computer is OFF and the jukebox standby/on switch is in the STANDBY position.
2. Plug the socket end of the power cord into the power port on the rear of the jukebox (see "1" on
PREVIOUS
power cord supplied with the jukebox.
3. Plug the other end of the power cord into a grounded electrical outlet.
JUMP
Caution:
4. Press the jukebox standby/on switch to ON.
CONTENTS
NOTE:
INDEX
5. Initially, TESTING appears in the display window on the front of the jukebox. Once the poweron test completes
(approximately 1.5 minutes), READY displays.
NOTE:
J
UKEBOX
P
OWER
J O
UKEBOX N
If you are changing SCSI IDs on the host bus adapter to avoid conflicts, change the IDs before turning host power
OFF.
If you are changing IDs on one (or two) of this jukebox to avoid conflicts, the following steps include this option.
Placing the standby/on switch to STANDBY does not remove all power from the jukebox. To remove all power (including primary
power) you must pull the jukebox power plug from the wall/floor receptacle.
If you are connecting two jukeboxes, place both jukeboxes to ON.
The remaining steps apply to both jukeboxes.
If FAIL 1 displays, the poweron test was not successful. Feel under the chassis at the location shown in
ensure that the shipping screw was removed. If the shipping screw was removed, refer to
3.
, A ID
DJUSTING
, T
S AND URNING
Figure 1-1). Use the
Figure 1-3
"Troubleshooting"
to
in Chapter
16