Message List
This is a list of messages recorded to the printer's system log. The system log can
be viewed using the syslog command.
System Log Information
You can use the following methods to view the system log.
• mshell : Use the syslog command
• Network Configuration Page : Configure PCL for the Printer Language, and
push the switch on the Network Interface Board while five seconds
"Network Configuration Page".
Message When the Network Interface Board Starts or Restarts.
RICOH Network Interface Board
Ver.x.x.x
PRINTER SYSTEM "system name"
Ver.x.x.x
Attach FileServer="file server name"
Current Interface Speed:xxxMbps
Current IPX address
Frametype="frame type name"
NetBEUI Computer Name="computer
name"
Start httpd
Start npmpd for IPX
Start npmpd for TCP/IP
Start smbd direct print mode(NetBEUI)
Start snmpd Ver.2.0
Vendor= , Country= , Lang=
P.65 "System Log Information".
The version number of the Network Inter-
face Board.
The system name and version of the print-
er.
The printer is attached to "file server
name" as the nearest server.
The speed of the network (10 Mbps or 100
Mbps).
The current IPX address.
The "frame type name" is configured to be
used on NetWare.
The NetBEUI Computer Name is defined
as "computer name".
The Web server has been started.
The npmpd for IPX protocol has been
started.
The npmpd for TCP/IP protocol has been
started.
You can print from a client on the Win-
dows network via the print server.
The SNMP agent of the displayed version
has been started.
The vendor, the country code, and the lan-
guage.
Message List
P.84
5
75