Getting Printer Information Over The Network - Ricoh Afico 180 Copy Reference Manual

Messages
Reset PCU
Reset Fusing
Unit Correctly
Resetting Job...
Reset Tray 1
Correctly
Reset Tray 2
Correctly
Warming Up...
Waiting...
Note
If you cannot solve the problem by taking above actions, turn the printer
power off and then back on again. If this does not clear the error message,
write down the error message, and contact your sales or service representa-
tive.

Getting Printer Information over the Network

Printer Current Status
You can check the printer's current status using the "mshel".
mshell
Use status command.
Reference
For more information, refer to the Operating Instructions of the optional
network interface board.
Messages
Add Toner
Call Service SC_XXX
Call Service Power Off
On
Description
The photoconductor unit is
not installed in the printer.
The fusing unit is not set cor-
rectly.
Job is being reset.
Tray 1 is not set correctly.
Tray 2 is not set correctly.
The printer is now preparing
for printing.
Printer is waiting for the next
data to print.
Description
The printer is out of toner.
The Service Code or SC num-
ber identifies the failure.
Communicate error from en-
gine to controller.
Error & Status Messages on the Operation Panel
Resolution
Call your sales or service
representative.
Set the fusing unit correctly.
Wait for a while.
Set tray 1 correctly.
Set tray 2 correctly.
Wait until the printer is
warmed up.
Wait for a while.
Resolution
Prepare a new toner car-
tridge.
Call your sales or service
representative.
Turn the machine off and
then on again to restart.
6
45