Charging The Battery - Panasonic DMC-LC40PP Operating Instructions Manual

Hide thumbs Also See for DMC-LC40PP:

Table of Contents

_ng

time and available recording time

shooting once every 30 seconds, flash every other shot. Measured using

supplk_l 16 MB SD Memory Card)

Supplied

battery pack

Approx.

120 min.

In setting

LCD monitor to ON

Approx. 150 rain.

(equal to 300 still pictures)

In setting LCD monitor to OFF

Approx. 180 min.

(equal to 360 still pictures)

_) Charging time

® Continuous

recording time (recordable

number)

•

Charging environment

and charging error

• Charge the battery in a place with a temperature of 50 - 95 F (10 - 35 °C). (The battery

shouldalso be the same temperature)

• When charging starts, the status indicator blinks at about 2 second cycles. If, after charging

starts, the status indicator blinks quicker, this indicates a charging error.

In this case, remove the AC adaptor from the electrical outlet, remove the battery and check

if both room and battery temperature is too low or high and then charge it again. (tt is not

possible to cancel the error by only turning the power off/on.) If the problem persists,

consult the dealer or your nearest servicentre.

Connecting to an Electrical Outlet

If you use an AC adaptor and connect it to an electrical outlet, you can use the camera

without worrying about battery discharge. The connection method is the same as

explained in "Charging the Battery". (P14)

• During use, the camera becomes warm; this is not a malfunction.

Table of Contents