Panasonic DMC-LC40PP Operating Instructions Manual page 91

........ Indications
[NO MEMORY CARD]
Insert the memory card.
[THIS MEMORY CARD IS PROTECTED]
Cancel the memory card lock.
[NUMBER OF PRINT IS OVER]
You have exceeded the number of
images that can be set at once, with
multi deleting, protect and DPOF
settings.
[NO VALID IMAGE TO PLAY]
Carry out playback after recording or
after inserting the memory card with a
recorded image.
[MEMORY CARD FULL]
Insert a new memory card or delete the
useless data.
[REMOVE LENS CAP AND PRESS SET
Bu'n'ON]
Remove the lens cap and then press
the [REVIEW/SET] button.
[CAN'T BE SET ON THIS PICTURE] /
[CAN'T BE SET ON SOME PICTURES]
If the image is not based on the DCF
standard, it is not possible to set the
DPOF.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
The format of this card cannot be
recognized by the camera. Format this
again with the camera.
[MEMORY CARD ERROR]
Failed access to memory card.
Insert the card again.
[READ ERROR]
Data reading error.
Play it back again.
[WRITE ERROR]
Data writing error.
Turn the camera [OFF] and remove the
card. Then insert the card and turn the
camera back [ON]. Be sure camera is
[OFF] before removing or inserting the
card to avoid damaging the card.
[THIS PICTURE IS PROTECTED]
After cancelling the protect setting, you
can delete or overwrite the image.
[THIS PICTURE CAN'T BE DELETED] /
[SOME PICTURES CAN'T BE
DELETED]
After cancelling the protect setting, you
can delete the image.
/
91