Panasonic DMC-LC40PP Operating Instructions Manual page 31

rding Motion
2 0
r_dn Ill
Images
With this camera you can also record motion
images. (If using the supplied 16MB SD
Memory Card, it is possible to record for
about 75 seconds)
[Preparations]
• Insert the card. (P16)
• Set the power switch to [ON]. (P18)
• Set the operational mode dial to single mode
[r--I]. (P25)
1
Set the REC mode dial to motion image
mode [_.
2 Center the subject in the focus area
on the LCD monitor and press the
shutter button halfway.
• When the focus is adjusted, the focus
indication [O] appears. ((_) Focus indication)
3
By pressing the shutter button fully,
the recording starts.
• The audio REC startssimultaneously.
4 By pressing the shutter button fully
again, recording stops.
• If duringthe recordingthe memory of the
card becomes full, the recordingis stopped
automatically
• In motion image record mode, the settings
listed below are not available
• Picturesize (P38)
• Built-inflash (P34)
• White balance (P52)
• ISO sensitivity (P54)
• The remaining time displayed on the LCD monitor is an approximation.
• You cannot record motion images without audio.
• If using the MultiMediaCard, after recording motion images, the screen may appear grey,
but this is not a malfunction.
• After recording starts, the auto focus and zoom are Tocked(with the first frame).
• Recording could suddenly stop when recording motion images.
31