Location Requirements; Choose The Proper Location; Clearances - Kenmore 402.8903 Series Use & Care Manual

KEY DiMENSiONS AND SPECiFiCATiONS
Description Dryer (Gas and Electric)
Electrical Requirements Please refer to the rating label.
Gas Requirements* NG: 6-8 in. WC
Gas Requirements* LP: 10-13 in. WC
Dimensions 27" (W) X 30 5/16"(D) X 38 s/l_" (H), 49" (D With door open)
68.6 cm (W) X 76.8 cm (D) X 97.1 cm (H),124.5 cm (D With door open)
Net Weight 120.2 lb. (54.5 kg)
Drying Capacity 402.8903 .... /402.9903 .... : IEC 7.3 cu.ft.
*Gas Models only.
LOCATION REQUIREMENTS
IMPORTANT:
Read all installation instructions completely before installing and
operating your dryer!
It is important that you review this entire manual before installing
and using your dryer. Detailed instructions concerning electrical
connections, gas connections, and exhaust requirements are
provided on the following pages.
CHOOSE THE PROPER LOCATION
Store and install the dryer where it will not be exposed to
temperatures below freezing or exposed to outdoor weather
conditions.
,, Choose a location with a solid, level floor.
,, If the dla!er is being installed in a garage, place the dryer at
least 18 in. (46 cm) above the floor.
Properly ground the dryer to conform with all governing codes
and ordinances.
To reduce the risk of electric shock, do not install the dryer in
damp or wet locations.
IMPORTANT: If you are installing your dryer in a manufactured or
mobile home, please refer to the section Special Requirements
for Manufactured or Mobile Homes on page 12.
CLEARANCES
Most installations require a minimum 4 in. (10 cm) clearance
behind the dryer for the exhaust ducting.
Allow minimum clearances of at least 1 in. (2.5 cm) on the
sides and back to minimize vibration and noise.
,, Allowing additional clearance for installation and servicing is
recommended.
Be sure to allow for wall, door, or floor moldings that may
increase the required clearances.
Allow at least 21 s/4 in. (55.2 cm) in front of the dla!er to open
the door.
20 s/4"(52.7cm)
HI
2" (5cm) _" _ 30 5/16" q_
(76.8 cm) J
49" (124.5 cm)
I_ 4" (10 cm)
Pl
1" (2.5cm)_ I-_k 27" _ _1" (2.5 cm)
(68.6cm)
3" (7.6 cm):
48 in2
(310 cm 2)
24 in2 ,,
(155 cm2)_
\
I" I
Closet Door Vent
Requirements
Additional instructions
for closet installations:
,, The closet door must
allow for sufficient airflow.
Refer to the diagram to
the left for minimum vent
opening requirements.
A Iouvered door is also
acceptable.
Kenmo:e Dryer Owners Manual-01 EN.indd 8 2010-06-17 _ C 3:33:41