Kenmore 402.8903 Series Use & Care Manual page 6

SAFETY PRECAUTIONS FOR CONNECTING ELECTRiCiTY
WARNING:
To reduce the risk of fire, electric shock, or injury to persons when using this appliance, follow basic
precautions, including the following:
• Do not, under any circumstances, cut or remove the
ground prong from the power cord. To prevent personal
injury or damage to the dryer, the electrical power cord must
be plugged into a properly grounded outlet.
For personal safety, this dryer must be properly
grounded. Failure to do so can result in electrical shock or
injury.
Refer to the installation instructions in this manual for
specific electrical requirements for your model. Failure to
follow these instructions can create an electrical shock hazard
and/or a fire hazard.
• This dryer must be plugged into a properly grounded
outlet. Electrical shock can result if the dryer is not
properly grounded. Have the wall outlet and circuit
checked by a qualified electrician to make sure the
outlet is properly grounded. Failure to follow these
instructions can create an electrical shock hazard and/or a fire
hazard.
The dryer should always be plugged into it's own
individual electrical outlet which has a voltage rating
that matches the rating plate. This provides the best
performance and also prevents overloading house wiring
circuits which could cause a fire hazard from overheated
wires.
• Never unplug your dryer by pulling on the power cord.
Always grip plug firmly and pull straight out from the
outlet. The power cord can be damaged, resulting in a risk of
fire and electrical shock.
Repair or replace immediately all power cords that have
become frayed or otherwise damaged. Do not use a
cord that shows cracks or abrasion damage along its
length or at either end. The power cord can melt, creating
electrical shock and/or fire hazard.
• When installing or moving the dryer, be careful not to
pinch, crush, or damage the power cord. This will prevent
injury and prevent damage to the dryer from fire and electrical
shock.
KenmoreDi?erOwnersManual-01 EN.indd 6 2010-06-17 _7 3:33:39