Kenmore 402.8903 Series Use & Care Manual page 15

VENTING THE DRYER {CONT.}
Routing and Connecting Ductwork
Follow the guidelines below to maximize drying performance and
reduce lint buildup and condensation in the ductwork.
NOTE: Ductwork and fittings are NOT included and must be
purchased separately.
Use 4-in. (102 ram) diameter rigid or semi rigid metal
duetwork.
The exhaust duct run should be as short as possible.
Use as few elbow joints as possible.
The male end of each section of exhaust duct must point
away from the dryer.
Use duct tape on all duct joints.
Insulate ductwork that runs through unheated areas in order
to reduce condensation and lint buildup on duct surfaces.
The Total length of flexible metal duct shall not exceed 8 ft.
(2.4 m)
In Canada, that only those foil-type flexible ducts, if any,
specifically identified for use with the appliance by the
manufacturer shall be used. In the United States, that only
those foil-type flexible ducts, if any, specifically identified for
use with the appliance by the manufacturer and that comply
with the Outline for Clothes Dryer Transition Duct, Subject
2158A, shall be used
WARNING:
Failure to follow these guidelines will
result in poor performance, product failure, and/or result in
fire or death.
IMPORTANT: Failure to exhaust the dla!er per the guidelines
included within these instructions may result in unsatisfactory
dryer performance. All venting and ductwork beyond the exterior
of the dryer is the responsibility of the consumer. Product
failure as a result of improper venting is not covered by the
manufacturer's warranty.
DEDO
Correct Venting
F
incorrect Venting
Connecting the Dryer Vent
1. Verify all ducts and elbows are clean and free from any
blockages.
2. Measure duct length. DO NOT exceed the maximum length
listed in the chart on page 14.
3. Connect dryer exhaust to existing ductwork,
Use duct tape or clamps only.
DO NOT use screws to secure ductwork.
Use rigid or semi rigid metal duct.
DO NOT use plastic or thin metal foil tubing for duetwork.
The male end of each elbow must always point in the direction
of the airflow.
Male ends
A
15
Kenmoie Dryer Owners Manual-01 EN.indd 15 2010-06-17 _ C 3:33:46