Report Programming; Zero Skip - Sharp UP-800F Instruction Manual

Report Programming

Use the following procedure to select any option included in the report group:
Procedure
▼
The following illustration shows those options included in the report programming group.
11 REPORT

■ Zero skip

You can program whether or not to skip "0" in each report.
Procedure
• TRANSACTION (Use the selective entry)
SKIP: Skips those data that are "0" in the transaction report.
NOT SKIP: Does not skip those data that are "0" in the transaction report.
• DEPARTMENT (Use the selective entry)
SKIP: Skips those data that are "0" in the department report.
NOT SKIP: Does not skip those data that are "0" in the department report.
• PLU (Use the selective entry)
SKIP: Skips those data that are "0" in the PLU/EAN report.
NOT SKIP: Does not skip those data that are "0" in the PLU/EAN report.
182
1.
2.
1 0 SKIP
2 GENERAL RPT FORMAT
3 TRANS. RPT FORMAT
4 CLERK RPT FORMAT
5 HOURLY REPORT
6 STACKED REPORT
Program each item as follows:
• CLERK (Use the selective entry)
• CASHIER (Use the selective entry)
From the SETTING menu, select "11 REPORT."
• The REPORT menu will appear.
Select any option from the following options list:
1 0 SKIP:
2 GENERAL RPT FORMAT: General report format
3 TRANS. RPT FORMAT:
4 CLERK RPT FORMAT:
5 HOURLY REPORT:
6 STACKED REPORT:
➡
See "Zero skip" on page 182.
➡
See "General report format" on page 183.
➡
See "Transaction report format" on page 184.
➡
See "Clerk report format" on page 186.
➡
See "Hourly report" on page 187.
➡
See "Stacked report" on page 188.
SKIP: Skips those data that are "0" in the clerk report.
NOT SKIP: Does not skip those data that are "0" in the clerk
report.
SKIP: Skips those data that are "0" in the cashier report.
NOT SKIP: Does not skip those data that are "0" in the
cashier report.
Zero skip
Transaction report format
Clerk report format
Hourly report
Stacked report