Table of Contents
Advertisement
Cable Management
To make an opening to route cables through
5
projector mount assembly, adjust projector mount
assembly to full upward tilt position and maximum
left or right roll position by turning knobs for
adjustments as shown in figure 5.1.
NOTE: Be certain tamper resistant screws are
not engaged before making adjustments (see
step 6-1).
Route cables through top of extension column as
shown in figure 5.2 and figure 5.3.
NOTE: A method for assisting cables through ex-
tension column may be required (example: string
tied to connector to help pull through extension
column).
Route cables through projector mount assembly as
shown in figure 5.4 and connect to projector.
EXTENSION
COLUMN
fig. 5.2
Visit the Peerless Web Site at www.peerlessmounts.com
KNOB FOR ROLL
ADJUSTMENT
fig. 5.1
CABLES WITH COMBINATION
OF VGA CONNECTOR
AND RCA PLUGS
BEND WIRES OF RCA
PLUGS IN OPPOSITE
DIRECTION
ROUTE
CONNECTOR
THROUGH
FIRST
DO NOT
CRIMP
WIRES
10 of 12
For Technical Support Contact Peerless Mounts at 1-800-729-0307 or 708-865-8870.
KNOB FOR TILT
ADJUSTMENT
OPENING FOR
ROUTING CABLES
fig. 5.3
MAXIMUM DIMENSIONS
EXTENSION COLUMN
WILL ALLOW
HEIGHT DIMENSION
WILL VARY DEPENDING
ON WIDTH DIMENSION
fig. 5.4
ISSUED: 04-01-08 SHEET #: 055-9254-7 04-21-10
MAXIMUM
WIDTH
1-9/16"
(40 mm)
Advertisement
Table of Contents
