Turning The Equipment On And Off - Epson ELP-3000 Owner's Manual

Turning the Equipment On and Off

20
2
l
Always turn on the projector and its attached equipment in the following order:
1. Monitor
2. Video source
3. Audio source (if different than computer or video source)
4. Projector
5. External amplified speaker or PA system
6. Computer.
The projector's power switch is at the back When you turn on the projector, the
green power indicator comes on and the lamp begins to warm up. Remove the
lens cap. After a few seconds, an image appears on screen.
Never look into the lens when the lamp is on. This can damage
Warning:
your eyes. It is especially important that children not look into the lens.
If the lamp does not come on when you turn on the projector, the projector may
be in standby mode. To turn off standby mode, press the Standby button on the
remote control.
To turn off the projector and other equipment, reverse the order shown above.
After you turn off the projector, the fan may remain on a few minutes to dissipate
heat from the lamp. Always wait 10 to 60 seconds before turning the projector
back on. If you turn on the projector immediately after turning it off, the lamp
might be too hot and the projector will not turn on.
Using the Projector