Replacing The Fuse - Epson ELP-3000 Owner's Manual
Epson owner's manual projector elp-3000
Hide thumbs
Also See for ELP-3000:
- Product support bulletin (9 pages) ,
- Product information (2 pages) ,
- Easy setup (1 page)
Table of Contents
Advertisement
Replacing the Fuse
When you need to replace the fuse, use only a 250 V, 6.3 AT fuse appropriate for
your voltage. Follow these steps:
1. Turn off the projector and disconnect the power cord from both the back of
2. Turn the projector so its back panel is facing you. The fuse holder is located
3. Remove the fuse holder by inserting a screwdriver or similar object into the
the projector and the wall outlet.
below the power switch.
groove. Then pry out the holder.
Replacing the Fuse
n n n n n n
61
Advertisement
Table of Contents
