Controlling The Projector - Epson ELP-3000 Owner's Manual

Controlling the Projector

Normally you control the projector using the remote control. The buttons on the
remote control allow you to do the following:
l
l
l
l
l
The functions of the remote control buttons are summarized on page 25.
To use the remote control, always point it toward one of the two remote control
receivers. One is located at the front of the projector; the other is located on the
back. You can use the remote control up to 33 feet (10 meters) from the projector.
In addition to the remote control, you can control the projector by:
l
l
Switch between the computer and video images
Adjust the brightness, volume, and synchronization
Turn standby mode on or off
Access the menus to adjust the image, audio, video, or display settings
(described in Chapter 3)
Control your computer (described in Chapter 4).
Pressing the buttons on the projector's operation panel, located on top of the
projector. These buttons duplicate the buttons on the remote control.
Running the ELP Link software on your computer. This program contains
the same controls available on the remote control, including the menus.
See page 26 for more information.
Controlling the Projector
23