Advertisement
5.
Repair
and
adjustment
5. Reparatur
und Einstellung
5. R_parations
et r_glages
5. Herstellen
en afstellen
5. Riparazioni
e messa
a punto
5. Reparaci6n
y ajuste
(_t.
Handle (low position)
2.
Handle (high position)
3.
Handle lock lever
4.
Belt guide
5.
Engine
pulley
6.
Idler pulley
7.
Extention
spring
8.
Transmission
pulley
9.
Drive control cable
10. Cable clip screw
Position
handle
Loosen handle lock lever (fig. 16). Handle can be positioned
at different settings between "high" and "low" positions (fig.
16). Retighten handle lock lever.
NOTE!
Select handle height suitable for you end your tilling condi-
tions. Handle height will change when tiller digs into the soil.
,_
WARNING!
Stop the engine and remove the spark plug wire and cover
from the spark plug (fig. 7) before cleaning out the tines by
hand. Use caution - tines are sharp.
Figure
16
3
5
CAUTION!
Place blocks under transmission to keep tiller from tipping.
Ground drive belt adjustment
For proper belt tension, the extension spring (fig. 17) should
have about 5/8 inch stretch with drive control bar in engaged
position (fig, 9). This tension can be obtained as follows.
a.
Loosen cable clip screw securing the drive control cable
(fig. 17).
b.
Slide cable fonNard for less tension and rearward for
more tension until about 5/8 inch stretch is obtained,
c.
Tighten cable clip screw securely.
Figure
17
10
6
7
8
52
Advertisement
