Solving Problems With The Image Or Sound - Epson PowerLite 505c User Manual

Solving Problems
94
Solving Problems with the Image or
Sound
No image appears on the screen.
Check that the power light is green, not flashing, and the lens cap
is off.
The projector may be in sleep mode. If the power light is orange,
press the button to turn the projector on.
Power
If the power was switched off and then on again, the projector
may still be cooling down. Wait until the power light stops
flashing and remains orange; then press the
Make sure the
Brightness
See page 73 for more information. Try selecting the
setting to return all setup menus to their default values.
Press the
A/V Mute
turned off temporarily.
The attached computer may be in sleep mode or displaying a
black screen saver. Try pressing a key on the computer.
You see a blue screen with the message No Signal
displayed.
Make sure the cables are connected correctly, as described in
Chapter 1 or Appendix A.
Try restarting your computer.
If you've connected a computer and one or more video sources,
you may need to press the
the , , or
Comp Video
select the correct source. Allow a few seconds for the projector to
sync up after pressing the button.
setting on the Video menu is correct.
button to make sure the picture has not been
button (on the projector) or
Source
button (on the remote control) to
S-Video
button again.
Power
Reset All