Epson PowerLite 505c User Manual page 102

Refer to the following table for a complete description of the
projector's status lights and their meaning:
Status lights
Light Status
orange
flashing green
green
flashing orange
flashing red
red
flashing orange
flashing red
flashing orange
red
flashing red
Description
The projector is in sleep mode. You can unplug it or press the Power
button to turn it on.
The projector is warming up. Wait for the image to appear.
The projector is operating normally.
The projector is cooling down. You can't turn it back on (and you
should not unplug it) until the light stops flashing and remains orange.
Power is cut off because of an internal problem. Remove the power
cord and contact EPSON for help.
The lamp is burned out. Replace it as described on page 86.
The lamp is almost burned out. This is a good time to replace it. See
page 86 for instructions.
There is a problem with the lamp. If necessary, replace the lamp as
described on page 86.
The projector is in a high-temperature cooling cycle. Make sure the
temperature surrounding the projector does not exceed 104 F and
there is plenty of space around and under the projector for ventilation.
Clean the air filter if necessary. See page 85 for instructions.
The projector has overheated and turned itself off. Let it cool for a few
minutes, then turn it back on. Make sure there is plenty of space
around and under the projector for ventilation. If it continues to
overheat, you may need to change the air filter. See page 85 for
instructions.
There is a problem with the cooling fan or temperature sensor. Turn
off the projector and unplug it. Contact EPSON for help.
Solving Problems
93