Table Extensions; Roller Support - Craftsman 315.212350 Operator's Manual

TABLEEXTENSIONS
See Figures 11 - 12.
Table extensions can be Installed in either the left or the
fight side of the base.
To Instalh
• Insertthe ends of the table extensionsintothe holesin
the side of the base and adjustthe extensionsto the
desired length.
• Secure extensionsin place by positioningthe clamp
bracket under the extension beneath the base. Orient
the clamp bracket as shown in figure 12.
• Using the clamp bracket boil, secure the clamp
bracket In place.
NOTE: The clamp bracket bolt threadsthrough the
clamp bracket and tightens against bracket supporton
bottom of base, securing clamp bracket against table
extensions.
ROLLER SUPPORT
See Figure 13.
• Turn the rollersupport upside down.
• Spin the wing nut on the leveler clockwiseuntilthe
wing nut is positionedin the middle of the thre=ds.
• Screw the leveler into the center brace of the roller
support.
• Turn the relier support upright.
• With the table extensionssecured In the saw's base,
slide the miler support onto the extensions.
• Tighten the wing nut on the back of the rollersupport
secudng It to the table extensions.
• The levelermust sit firmly on the surfacethe s_w is
mounted to. Adjust the leveler up or down as needed.
• Once the leveleris in the proper position,turn the lever
wing nut until the wing nut is tight agalnstthe center
brace.
TABLE
EXTENSION
BASE
CLAMP
BRACKET
CLAMP
BRACI(ET S CREW
SAWV1EWED FROMBOTTOM
WINGNUT ROLLER SUPPORT
TABLE EXTENSION
Fig. 12
TABLE
EXTENSION
WINGNUT
LEVELER
Frg. 13
FABLE MITER
EXTENSION SAWBASE
Fig. 11
16