Assembly; Unpacking; Mounting Holes; Mounting Surface - Craftsman 315.212350 Operator's Manual

12 in. compound miter saw double insulated
Hide thumbs Also See for 315.212350:
Table of Contents

Advertisement

UNPACKING
This product requiresassembly.
• Carefullylift saw from the cartonby the carryinghandle
and the saw base, and place it on a level work surface.
NOTE: This saw is heavy.To avoid back injury,liftwith
your legs, not your back, and get help when needed.
Thissaw has been shippedwith the saw arm secured
In the down position.To release the saw arm, push
down on the top of the saw arm, cut the tie-wrap, and
putt out on the lock pin.
Lift the saw arm by the handle. Hand pressureshould
remain on the saw arm to preventsudden rise upon
release of the tie wrap.
Inspectthe tool carefullyto make sure no breakage or
damage occurred duringshipping.
Do not discard the packing material untilyou have
carefullyinspected and satisfactorilyoperated 1hetoot.
• The saw is factory set for accurate cutting.After
assemb)tngit, check for accuracy,tt shippinghas
Influencedthe settings, refer to specificprocedures
explainedtn "this manual.
If any parts are damaged or missing, please call
1-800-932-31B8 for seslstance.
WARNING:
If any parts are miSSing, do not operate
this tool until the mlss(ngparts are replaced. Farfure
to do so could resultin posalbteserious personal
injury.
,_1 WARN|NG: Do not attempt to modify thistool
or create accessoriesnot recommended for use
with this tool. Any such alterationor modification is
misuse and could result In a hazardouscondition
leading to possibleserious personalinjury.
_IL WARNING: Do not connectto power supply until
assembly is complete. Failure to complycould result
in accidental startingand possibleseriouspersonal
Jnluty.
MOUNTING HOLES
See Figure7.
,_
WARNING" Always make surethe compoundmiter
saw Is securelymounted to a workbench or an ap-
provedworkstand. Failureto heed this warningcan
res_tt in _,erious personaliniury.
The compound miter saw shouldbe permanentlymount-
ed to a firm supportingsurface such as a workbench.
Four boil holeshave been provided in the saw base for
this purpose. Each of the four mountingho]ss shouldbe
bolted securelyusing3/8 in. machine bolts, lock washers,
and hex nuts (not included). Bolts shouldbe of sufficient
length to accommodate the saw base, lock washers, hex
nuts, axedthe thickness of the workbench.
Tightenart four bolts securely.
The hole pattern for mountingto a workbench Is shownin
figure 8. Carefullycheck the workbench after mountingto
make sure that no movement can occur duringuse. It any
tipping, sliding,or walking Is noted, secure the workbench
to the floor beforeoperating.
"IRACE HOLES
_,
ATTHESE LOCATIONS FOR
HOLE PATTERN
/
BASE
TRACE HOLES
ATTHESE LOCATIONS F OR
HOLE PA'FrERN
MOUNTING SURFACE
Fig. 7
14

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents