Table of Contents
Advertisement
33.9 °
Fig.40
Bevel
Angte
Type of Cut
Setting
Leftside,insidecomer
33.85"
1.Topedge ofmolding against fence
2. Miter tablesetrJght 31.62"
3.Save leftend
of cut
Right side, Inside corner
1. Bottom edge of molding against fence
33.85"
2. Miter table set left 31.62"
3, Save left end of cut
Left side, outside comer
1. Bottom edge of molding against fence
_,3.65"
2. Miter table set left 31.62"
3. Save right end of cut
Right side, outside corner
33.85"
1. Top edge of molding against fence
2. Miter table set right 31.62"
3, Save right end of out
molding. Also mostwalls do not have angles of exactly
90",therefore,you will need to fine tune your settings.
When cutting crown molding by this method the bevel
angte should be set at 0".The miter anglo shouldbe set at
45"either right or left, dopondingon the desired cut for the
sppLLcation.
Usingthe markings on the throat plata, you can accurately
cut All Standard (U.S.)with 52"and 38"angles in sizes
of 2-3/4 in., 3-5/8 in., 4-5/8 in., and 5-1/4. You cannot
usa the markingson the throat platowhon cutting crown
moldingwith 45"and 45"angles.
• Loosenthe crown molding stop by turning the knob
countemlockwlse.
•
Place thes_oplntheholeon e1_er thetefl o r thadght
s_deof +_he s aw's _es. See figure 41.
• With the bottom of the molding (wall aide)against the
miter fence and the top of the molding(callingaide)
against the miter table, alignwith the desired mark on
the throat plate then spin the crown moldingstop until
it fits snugglyagainst the crown molding.
• Secure the crown molding stop in placa by turningthe
knob clockwise.
•
Hold the crown molding in place with your hand(the
side not securedwith the stop).
NOTE: NEVER haveyour hand inside the no hands
zone while the saw Is on,
• Slowty towerthe blade Into and through the workptece,
• Release the switch triggerand allow the blade to stop
rotat'mg before raisingthe blade out of workpiace.Wait
untilthe elactflc brokestopa blade from turning before
removJng the workplace from miter table.
CROWN MOLDING
STOP
_._
KNOB
I
!
CUTTING
MOLDING
USING
THE CROWN
MOLDING
STOP
See Figures41 and 42.
To use this method for accurately cutting crown molding
for a 90"inside or outside corner,place the crown molding
upside down on the miter table.
Keep in mind that the angles for crown moldingsare very
preciseand d]fficuitto set. Since it is very easy for these
engtes to shift, el!settingsshoutd first be tested on scrap
3O
Fig. 41
Hide quick links:
Advertisement
Table of Contents
