Modifying Dhcp Settings; Enabling Dhcp - Altigen Alti-IP 600H Administration Manual

Local
Network>Local
Address
Address
Network
Network>Network
Mask
Mask
Gateway
Network>Gateway
Enable
Network>Enable/
Gatekeeper
Disable
GateKeeper
GateKeeper
Network>GK
Discovery
Discovery
Enable NAT
Network>Enable/
Disable NAT
NAT Address
Network>NAT
Address

Modifying DHCP Settings

Dynamic Host Configuration Protocol (DHCP) automatically assigns IP
addresses to devices when they are connected to the network.

Enabling DHCP

The Alti-IP 600H automatically enables DHCP by default, but you can
reset the protocol if it becomes disabled using the following steps:
1. Press * * 7 + ENTER button.
2. Use / to select Network, then press the Enter key.
3. Scroll to Enable DHCP.
If DHCP is disabled, the option displays as DHCP Enabled NO.
4. Press (DOWN key) to enable DHCP.
Sets the IP phone's local address;
only shows if DHCP is disabled.
Sets the IP phone's network mask;
only shows if DHCP is disabled.
Sets the Gateway IP address.
Set whether GateKeeper is enabled or
disabled.
Set to YES or NO to indicate whether
GateKeeper discovery is enabled. IP
Phone will automatically find
GateKeeper.
Set whether NAT is enabled or
disabled.
Sets the NAT server's public IP
address.
Alti-IP 600H Manual 25