Windster WS-5530SS Operation Manual
Hide thumbs Also See for WS-5530SS:

Advertisement

(For residential and indoor use only)
Please read and save this guide through before using your range hood.
Store the guide away in a safe place so that you will know where it is,
when you want to refer to it.
OPERATION
MANUAL
WS-5530SS
WS-5536SS
WS-5542SS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WS-5530SS and is the answer not in the manual?

Questions and answers

Summary of Contents for Windster WS-5530SS

  • Page 1 WS-5530SS WS-5536SS WS-5542SS OPERATION MANUAL (For residential and indoor use only) Please read and save this guide through before using your range hood. Store the guide away in a safe place so that you will know where it is, when you want to refer to it.
  • Page 2: Table Of Contents

    Table of Contents Important Safety Instructions ---------------------------- Safety Notes ------------------------------------------------------ Tools and Materials Required ---------------------------------- Accessory Package -------------------------------------------- Preparing the Range Hood ----------------------------------- Preparing the Installation Location -------------------------- Providing Electrical Power ------------------------------------- Mounting Range Hood to Cabinet ---------------------------- Making The Electrical Connection ----------------------------- Mounting Range Hood Without Cabinet --------------------- Use and Care ------------------------------------------------------ P.10...
  • Page 3: Important Safety Instructions

    A. IMPORTANT SAFETY INSTURCTIONS CAUTION- To reduce risk of fire and to properly exhaust air, make sure to properly exhaust air. Be sure to duct air outside- Do not vent exhaust air into spaces within walls, ceilings, attics, crawl spaces, or garages. WARNING- To reduce the risk of fire or electric shock, do not use this fan with any solid- state speed control device.
  • Page 4 WARNING- To reduce the risk of injury in the event of a range top grease fire, observe the following: SMOTHER FLAMES with a close- fitting lid, cookie sheet, or metal tray, then turn off the burner. Be careful to prevent burns.
  • Page 5: Safety Notes

    B. SAFETY NOTES 1. All electrical work must be done in accordance with local and/or national electrical code as applicable for safety. This product must be grounded if your are unfamiliar with methods of installing electrical wiring, secure the services of a qualified electrician. 2.
  • Page 6: Tools And Materials Required

    C. TOOLS AND MATERIALS REQUIRED C. Tools and Materials Required Drill, electric of ratchet driver, with 3/16" wood bit (for drilling starter holes and 1 ” wood bit (to drill an access holes in the cabinet or ¼ kitchen wall for the electric power line) One common screwdriver.
  • Page 7: Preparing The Range Hood

    E. PREPARING THE RANGE HOOD E. Preparing The Range Hood 1. Remove the top electrical Electrical Knockout knockout, you may plan to bring power to the range hood either through the cabinet or through the wall (Fig.1) Fig.1 2. Insert a screwdriver into the knockout slot and bend the knockout back and forth.
  • Page 8: Preparing The Installation Location

    F. PREPARING THE INSTALLATION LOCATION 1. If you want to move the electric range to make room for working on the cabinet turn off the 220 volt power for the electric range at the service entrance. 2. Before moving a gas range, shut off the gas. NOTE: 1.
  • Page 9: Providing Electrical Power

    4. Screw the four 1" wood screws (for mounting the hood) into the exact center of the arrow and of the keyhole mounting slots marked on the cabinet bottom (for flush installations), or marked on the 1” x2” wood strips (for Strips secured recessed cabinet installation) (Fig.7) Do not turn the mounting screws in all...
  • Page 10: Mounting Range Hood To Cabinet

    H. MOUNTING RANGE HOOD TO CABINET 1. Position the hood in place so that : a. The electrical line is routed through the appropriate Knockout opening. This step will have to be accomplished while positioning the hood (Fig.10) b. The large part of the keyhole mounting slots on the hood fit onto the hood mounting screws projecting from the bottom of the cabinet.
  • Page 11: Mounting Range Hood Without Cabinet

    J. MOUNTING RANGE HOOD WITHOUT CABINET Bracket 1. Using metal brackets and screws (included), center hood onto Screw board and install screw. 2. Remove the hood from the board and nail the wood board onto the wall. (Be sure the nail is in the center of the stud) 3.
  • Page 12: Use And Care

    K. USE AND CARE Note : For stainless steel type, peel off the PVC films before use. Operate switches (Fig.15) Switch A : Light switch Switch B : Right fan switch Switch C : Left fan switch II- high speed 0- off I- low speed Fig.15...
  • Page 13: Maintenance Instruction

    L. Maintenance Instruction L. MAINTENANCE INSTRUCTION 1. Maintenance shall be important than repair. Please take care of the needed maintenance in order to secure and extend the excellent functions and using life. Note: Before repairing the range hood. Disconnect the power source. 2.
  • Page 14: Troubleshootings

    N. Troubleshootings N. TROUBLESHOOTINGS Symptom Correction A. Check power source to see if it is normal. Fan are not operatable. B. Check power inlet plug to see if it is plugged firmly into it's socket. A. Disconnect the power source. Illuminating light B.
  • Page 15: Parts Layout Diagram

    Q. PARTS LAYOUT DIAGRAM Q. Parts Layout Diagram...
  • Page 16 PARTS LIST Parts List Description Parts no. Per hood Hood casing 55-01 Air chamber 55-02 Bottom board 55-03 Wire box 55-04 Motor housing 55-05 Oil collector (large) 55-06 Motor (L/R) 55-07 Fan (L/R) 55-08 Oil tunnel 55-09 Safety mesh (L/R) 55-10 Oil collector (small) 55-11...
  • Page 17: Recirculation Kit Installation

    R. Recirculation Kit Installation (optional) Note: Before mounting the range hood and recirculation kit, please must refer the S. Size following from the manual. 1. P.5 “E. Preparing the Range Hood” remove the top electrical knockout (recirculation kit is same step) 2.
  • Page 18: Limited Warranty

    1) Labor: For a period of one (1) year from the date of purchase, if this product is determined to be defective, Windster will repair or replace the product, at its option, at no charge. After the warranty period, you must pay for all labor charges.
  • Page 19 EXCEPTIONS. Return Policy Windster offers only the best and highest quality products. If you are not satisfied with your purchase, please contact us within 3 business days of product arrival to obtain a Return Merchandise Authorization (RMA). Returns sent without a RMA will not be accepted.
  • Page 20 . w i n d s t e r h o o d . c o m 5101 Commerce Dr Baldwin Park, CA 91706 TOLL FREE: 1-877-350-5215 FAX:(626)962-8669 © Windster Hoods, Inc. Specifications subject to change without notice.

This manual is also suitable for:

Ws-5536ssWs-5542ssRa-77 series

Table of Contents