Selecting Finishing Mode; Finishing Modes And Optional Finishing Devices - Kyocera TASKalfa 650c Copying Manual

3 BASIC COPY MODES

Selecting Finishing Mode

Finishing modes and optional finishing devices

See the table below for each finishing mode.
Finishing mode
Non-sort Non-staple
Sort ( P.74)
Group ( P.74)
Rotate sort ( P.75)
Staple sort ( P.77)
Magazine sort ( P.79)
Saddle stitch ( P.79)
Magazine sort & saddle stitch
( P.79)
Hole punch ( P.81)
Manual staple ( P.83)
The available finishing modes differ depending on the type of optional finishing devices (Finisher and Hole Punch Unit)
installed. Finishing devices available for this equipment are as follows:
Finisher
Finisher DF-800
Saddle Stitch Finisher DF-810
Hole Punch Unit
Hole Punch Unit PH-6
Check the finishing modes enabled with each finishing device.
Devices
Group
DF-810 &
PH-6
DF-810
DF-800 &
PH-6
DF-800
No device
72

Selecting Finishing Mode

Copies exit without being sorted or stapled.
Copies exit in the same page order as the originals one set after another.
Copies grouped by page exit.
Copies exit set by set alternately in a different direction.
Copies exit with their corner stapled.
Copies exit in a book-type page order.
Copies in a book-type page order exit with their center folded and stapled.
Magazine sort and saddle stitch are used together.
Copies exit with their side punched.
Copies are stapled manually.
Sort/ Rotate Staple
sort sort
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes —
Description
Finishing mode
Magazine
Magazine sort & Saddle
sort saddle stitch
stitch
Yes Yes Yes
Yes Yes Yes
Yes —
Yes —
Yes —
Hole Manual
punch staple
Yes Yes
— Yes
— Yes Yes
— — Yes
— — —