Intergraph InterServe 650 Setup Manual page 64

50
Mouse Support
This parameter enables or disables mouse support in AMIBIOS Setup. The values are
Enabled (default) and Disabled. If disabled, the mouse will not function in AMIBIOS Setup,
and you must use the , , and arrow keys to navigate the menus.
TAB ENTER
Typematic Rate
This parameter defines the rate at which a keystroke repeats when you press and hold down a
key. Accepted values are 15, 20, 24, or 30 (default) characters per second.
System Keyboard
This parameter enables or disables BIOS keyboard testing. Acceptable values are Absent and
Present. If Present (default) is selected, the BIOS tests for the keyboard when the system
boots and provides an error message if the keyboard is not present. If Absent is selected, the
BIOS does not test for the presence of a keyboard.
Password Checking
This parameter prevents unauthorized system boot up or use of AMIBIOS Setup. The default
value is Setup, enabling the system to prompt for a password before allowing you to enter
AMIBIOS Setup. If you chose the value Always, the password prompt appears each time the
system is powered on. The Change Password value enables you to press at the
ENTER
password prompt to disable this parameter.
NMI on System Error
This parameter halts the system when a catastrophic error is detected. This prevents the error
from corrupting your data. The default is Enabled.
Wait for 'F1' on Error
When set to Enabled (default), the system will display the Press <F1> to RESUME
message if an error occurs during boot up diagnostic tests. If this setting is Disabled, any non-
fatal errors will not generate the statement, but the AMIBIOS will display the appropriate
error message.
Hit 'DEL' Message Display
When set to Enable (default), the system provides a message during boot up that the
AMIBIOS Setup program can be accessed by hitting the key. Disabling this parameter
DEL
prevents the message from displaying.