Table of Contents
Advertisement
4.
5.
6.
If you have ISDN PRI T1 or ISDN PRI E1 trunk boards, go to the next section. Otherwise,
perform any other required board-specific configuration steps described in the table on page
7-19. When you are done, go to "Test-starting the Intel Dialogic drivers" on page 7-33.
Configuring ISDN PRI T1 or ISDN PRI E1 trunk boards
DM3 boards: Specifying the ISDN protocol to use
For DM3 boards, the ISDN protocol is determined by the firmware file you selected according
to the instructions in "Assigning firmware files to DM3 boards" on page 7-14.
For example, if you are using the NI2 protocol with a DM/IP241-1T1-P100 board, select the
firmware file
For specifics on which DM3 boards provide ISDN T1 and E1 resources, see Appendix E, "Intel
Dialogic Telephony Board Specifications."
7-22
Choose
from the
RXGAIN_N1
Click
.
OK
Repeat for each additional analog trunk board.
@ipvs_evr_isdn_ni2_Ml11_311.fcd
drop-down list.
Value
.
I
I
NSTALLING
NTEL
T
C
ELEPHONY
OMPONENTS
Advertisement
Table of Contents
Troubleshooting
